Graco 25A693, Instructions Manual

Page: 64 / 166

Using the Setup Screens
Configure Configure Configure Each Each Each Station Station Station
When the stations have been created
(
Create the Stations, page 63 ), each station
must be individually configured.
Use this procedure to specify the equipment installed
in one specific station. If the system contains multiple
stations, use this procedure separately for each
station.
Figure 63 Station Configuration Screen
1. Press on any Run screen to enter the Setup
menu screen.
2. Press Station Station Station Configuration Configuration Configuration.
3. On the Station Configuration screen, press the
Station
Station
Station Number
Number
Number field.
NOTE: For a newly created station, all fields on
the Station Configuration screen contain No
No
No or
None None None.
4. On the Station Station
Station Number
Number
Number keypad, enter the number
of the station to be configured.
5. One at a time, press each item’s response field
and use the keypad to specify the equipment
used in the selected station.
For a list of field descriptions, see
Fields on the Station Configuration Screen .
6. A node ID is automatically generated for each
paint kitchen component that communicates
directly with the Intelligent Paint Kitchen software.
Make a note of each node ID and the component
for which it was created. Enter each ID
its component, following the instructions in
Enter the Node IDs, page 44 .
7. Repeat steps 3–6 for each additional station in
the system.
64 3A4030C