Pump
24
3A5082G
Programming ON Time
NOTE:
When programming a time of less than 10
minutes
you
must
program a leading zero in the first
number field and press the ENTER button to save the
zero selection.
1.
To set the ON Time use the
UP or DOWN ARROW button
to scroll through numerals 0
to 9 until the desired number
appears in the first MM
(minutes) field.
2.
Press the ENTER button to lock in the
selection. The next MM number field to
the right flashes indicating it is ready for
programming.
3.
Use the UP or DOWN
ARROW button to scroll
through numerals 0 to 9 until
the desired number appears
in the second MM number
field.
4.
Press the ENTER button to lock in the
selection.
The next number field to the right
flashes and the LED lights under SS; indicating it is
ready to program the seconds fields.
5.
Repeat steps 1 - 4 to set the SS (seconds) fields.
6.
After pressing the ENTER button to set
the last SS field, all the programmed ON
Time information is saved.
The automatically switches to the OFF Time SETUP
MODE.
PUMP OFF / REST Setup
After setting the parameter for ON time, the OFF or
pump rest cycle must be set up for a specific set amount
of time (similar to Time Mode).
OFF Time
•
The LED next to the clock in the OFF
field lights, indicating you are setting
the OFF Time parameters.
•
OFF Time is set in Hours and Minutes
(HH: MM).
•
An LED flashes under
either HH when
programming hours
OR
MM when
programming minutes.
•
In SETUP MODE the
number displayed in
the first field, on the
left side of display
blinks, indicating the
device is ready to
program the OFF Time hours.
•
The total amount of OFF Time must be
at least twice as long as the
programmed ON Time. If a value less
than twice the ON Time is entered, the
RED alarm LED lights and the value must be
updated.
If this time does not meet the application needs,
contact Graco Customer Support.
Programming OFF Time
NOTE:
When programming a time of
less than 10
hours
you
must
program a leading zero in the first
number field and press the ENTER button to save the
zero selection.
1.
To set the OFF Time use the
UP or DOWN ARROW button
to scroll through numerals 0
to 9 until the desired number
appears in the first HH (hour)
field.
2.
Press the ENTER button to lock in the
selection. The next HH number field to
the right flashes indicating it is ready for
programming.
OR
