Graco 24Y858, Installation And Operation Instructions Manual

Page: 14 / 36

Installation
14 3A2592M
Adjusting Spring Tension
Increasing Spring Tension
1. Disconnect cord reel from power source by unplug -
ging power cord from outlet.
2. Pull out accessory cord, 1 to 2 turns and engage
pawl.
3. Pull accessory cord back through cord rollers.
4. Wrap a loop of accessory cord onto the spool.
5. Check the spring tension; the accessory cord must
pull out fully and retract fully. Wrap more loops, one
at a time around the spool until the spring has the
desired tension.
NOTE : Do not put so many loops onto the reel that the
spring winds up tightly before the accessory cord is
fully extended.
Decreasing Spring Tension
1. Disconnect cord reel from power source by unplug -
ging power cord from outlet.
2. Pull out accessory cord, 1 to 2 turns and engage
pawl.
3. Pull accessory cord back through cord rollers.
4. Remove loops of accessory cord to decrease ten -
sion.
5. Check the spring tension. Unwrap more loops, one
at a time from the spool until the spring has the
desired tension.
• Never allow reel to spin freely. Doing so could
cause serious injury if you are hit by the plug,
accessories, or other moving parts.
• Reel must be bolted securely in place when mak -
ing adjustments.