Maintenance
46
3A2797ZAA
Install Upgrade Tokens
NOTE:
The Motor Control Module, Fluid Control Mod
-
ule, and Temperature Control Module connection to the
system is temporarily disabled during the installation of
upgrade tokens.
To install software upgrades:
1. Use correct software token stated in the table. See
Graco Control Architecture
™
Module Programming
manual for instructions.
NOTE: Upgrade all modules in the system to the
software version on the token, even if you are
replacing only one or two modules. Different soft
-
ware versions may not be compatible.
All data in the module (System Settings, USB Logs,
Recipes, Maintenance Counters) may be reset to
factory default settings. Download all settings and
user preferences to a USB before the upgrade, for
ease of restoring them following the upgrade.
See manuals for locations of specific GCA compo
-
nents.
The software version history for each system can be
viewed in the technical support section at
www.graco.com.
Programming Tokens/Updating
System Software
On system software version 1.12.001 (February 2020)
and later, a single 16H821 programming token can be
inserted into the ADM to re-program most of the soft
-
ware modules, after power is cycled. To update the
16C014 “MCM Component Blue” software, the 16H821
token must be installed into the MCM module, then
page 68 in
Appendix B - ADM Setup Screens Over
for a list of the HFR module software components.
On system software version 1.12.014 and later (Octo
-
ber 2020), the capability to program a token using the
HFR ADM module and a USB stick (16 gigabytes or
smaller) is provided. The user must to obtain the latest
16H822 HFR software, and move the file onto the USB
stick in the following directory location:
\GRACO\SOFTWARE\16H822.gti
To program an HFR token and update the software,
perform the following steps:
Token
Application
16H821
HFR
:
- Advanced Display Module
- Motor Control Module
- High Power Temperature Control Module
- Fluid Control Module (AC Power Pack)
- Discrete Gateway Module
- Communication Gateway Module
16G407
Ratio Monitoring (Flow Meters)
:
- Fluid Control Module
F
IG
. 26: Remove Access Cover
r_257396_3b9905_04b
ti12334a1
ti12358a1
ti12354a1
Summary of Contents for 24N572
Page 31: ...Setup 3A2797ZAA 31...
