grace design m201
mk2
owner’s manual
5
Rearpanel Connections
microphone
preamplifier
m
201
mk2
GRACE DESIGN
LYONS, CO USA
2
1
MIC
OUT
OUT
MIC
OUT
OUT
m201 mk2
SERIAL #
MICROPHONE PREAMPLIFIER
250V~ T 200 L
FUSE
100-240V~ 50-60Hz 5W
GRACE DESIGN / LUNATEC LLC
LYONS, CO 80540
<xxxxxxx>
A
B
microphone
preamplifier
m
201
mk2
GRACE DESIGN
LYONS, CO USA
2
1
MIC
OUT
OUT
MIC
OUT
OUT
m201 mk2
SERIAL #
MICROPHONE PREAMPLIFIER
250V~ T 200 L
FUSE
100-240V~ 50-60Hz 5W
GRACE DESIGN / LUNATEC LLC
LYONS, CO 80540
<xxxxxxx>
C
A
IEC POWER INPUT, FUSE HOLDER AND POWER SWITCH
A 6’ AC power cord is supplied to connect mains
voltage (100-240 VAC) to the preamplifier unit.
The power switch connects / disconnects the
mains voltage to the preamplifier. Fuses are two
T250mA 250V~ 5mm x 20mm Time Delay Fuses.
B
XLR OUTPUT CONNECTORS (PARALLEL)
Output connections are made via male XLR con-
nectors with pin 2 positive, pin 3 negative and
pin 1 ground. An additional set of parallel XLR
outputs are provided for sending line signals to
additional recording devices or mixers.
C
XLR MIC INPUT CONNECTOR
Input connections are made via female XLR con-
nectors with pin 2 positive, pin 3 negative and
pin 1 ground. 48V phantom power is supplied
on pins 2 and 3.
Installation
POWER CONNECTION
The m201mk2 has a built-in universal power supply which accepts line voltages of 100
to 240VAC. We include power cable specified for the country where it was ordered, so
it should be supplied correctly. If not, please contact your dealer or distributor for help.
For safety, it is recommended that the AC power cable be connected to a grounded
outlet. The Disconnect Device for the m201mk2 is the rocker switch on the AC power
entry module. The Disconnect Device must remain accessible and operable.
TURNING THE POWER ON
The power switch is located on the rearpanel in the IEC 320-C14 power entry module. Switching the
rocker switch to the
I
position turns the mains power on. Switching the rocker switch to the
O
posi-
tion turns the mains power off. The front panel standby switch turns power to the m201mk2 audio
circuitry on and off and will illuminate green when the power is on.
