grabner HAPPY CAT LIGHT, Owner'S Manual, Page: 32 / 44

32
Attention: Rinse the boat accurate after
use in salt-water and clean all connec-
tionparts to avoid damages by corrosi-
on - see „care and storage“ in operating
instructions part 2.
► pack-sack: stow rolled up float-tubes.
Air-pump and small sundries (lines, mas-
thead fly …)
For
NEO
, the float tubes are divide in bag 1
and 2.
► Bag 1: Place the rear frame element, up-
per side facing down into the bag. Place
both frame side elements, undersides fa-
cing each other over the connector lugs
of the rear frame element. Then add the
centerboard- and rudder blade along the
frame elements. Lay the trampoline cloth
on top and close the bag.
► Bag 2: Place the forward frame element,
upper side facing down into the bag. Add
the 4 mast sections, bowsprit and cross
bar. Lay the sails on top and close the
bag.
► Carrying bag for sails: The rolled-up
sails
► Optional accessories (foredeck cover,
paddles, seat cushions, gennaker …)
may be added to suit.
pACkING
ADvICE ON SAIlING
The furling gear enables the foresail area to
be reduced and thereafter to be increased
again.
► Take the fore sheets off the cleats.
► Pull the starboard furling line – the fo-
resail reels in.
► To increase the sail area again, pull at
one end of the fore sheet. The sail now
unfurls.
ENDlESS fURlING JIB
ATTENTION: Always roll in the headsail,
pull on the right line.
The hole point of the mainsheet can be shif-
ted with the traveller.
► Shift the hole point on the desired positi-
on to luff or lee.
► Place the traveller-line into the luff sided
cleat of the rear frame element.
► To change the position, remove the tra-
veller-line from the cleat and shift to the
new position.
TRAvEllER
The mainsheet can be hooked into the clew
plate in five positions.
► Light wind - rear eye
► Strong wind - front eye
ClEW plATE
► Roll up the tubes starting from the front
to the rear towards the valves.