EN
18
Setting Up and Connecting the Device
1. Fully unwind the appropriate connecting cable (
1, 2
).
2. Set up the device with a clear space at the sides and clear space above it (at least
30 cm) on a
fl
at, solid, heat-resistant and hard-wearing surface.
3. Plug the connecting plug for the chosen connecting cable into the appropriate con-
necting socket on the back of the device:
Connecting cable with mains plug
►
220 V
connecting socket
(
12
)
Connecting cable with the car adapter
►
12 V
connecting socket (
13
)
4. Plug the mains plug or car adapter into a properly installed plug socket or cigarette
lighter.
PLEASE NOTE!
The On / Off switch (
14
) should be in the
OFF
position during
connection.
Overview of Functions
The device has two different modes: keep-warm mode and cooling mode. Move the
On / Off switch (
14
) to the position you want to choose between the modes.
Position
Function
Control lamp
OFF
Device is switched off
Both control lamps
switched off
HOT
Device is in keep-warm
mode (approx. 50°C)
Keep-warm control lamp is
lit up red
COLD
Device is in cooling mode
(approx. 20°C below ambi-
ent temperature)
Cooling control lamp is lit
up green
Use
PLEASE NOTE!
■
Before switching from one mode to another, the device must be switched off and you
must wait for at least 5 minutes!
• When
you
fi
rst use the device, it can take up to 12 hours for the device to
get to the optimum temperature. The more frequently the device is used, the
faster the device will reach its target temperature.
• To preserve the car battery, do not operate the device via the cigarette lighter
when the car’s engine is off.
• We recommend that food, cans or bottles which are to be cooled are pre-
chilled before they are laid down or placed in the device.
1. Connect the device (see the “Setting Up and Connecting the Device” chapter).
2. Move the On / Off switch (
14
) to the
HOT
or
COLD
position to switch on the device
in the mode you want. The corresponding control lamp goes out (see the “Overview
of Functions” chapter).