Operating Manual HG G-98830YA | English, Revision 02 | Date: 21.06.2021
6
Chapter 1 – About this Operating Manual
1
About this Operating Manual
1.1 Validity
This operating manual applies to the transponder antenna HG G-98830YA.
The manual comprises information on correct mounting, electrical installation, com
-
missioning, operation, maintenance and troubleshooting.
This operating manual refers to devices from Firmware 98830A21.004 (see Figure
23 on page 50).
1.1.1 Target group
This operating manual is intended for
developers, manufacturers or operators of systems who want to position mov
-
ing parts or automatically guide vehicles with the support of the transponder
antenna HG G-98830YA,
any technical staff of a manufacturer planning to integrate the transponder
antenna into an Automated Guided Vehicle (AGV) or to use the RFID-based
position detection and identification function in another way,
qualified persons who integrate the transponder antenna into a vehicle or
mobile robot, put it into operation for the first time or configure it.
1.1.2 Additional Applicable Documents
This manual does not provide any information concerning the operation of the high
-
er-level system, e.g. an Automated Guided Vehicle (AGV), in which the transponder
antenna is integrated.
Do not put the transponder antenna into operation until you have received the
manual of the manufacturer or the system operator and have read and
understood them.
Supplementary documents are available on request or directly from
our website. The QR code on the right takes you to our homepage
. The following links refer to specific product
pages.
–
Disc transponder HW DEV00095/00098
http://www.goetting-agv.com/components/00095
–
Rod transponder HG G-71325XA
http://www.goetting-agv.com/components/71325
–
Transponder programming device HG G-81840
http://www.goetting-agv.com/components/81840
–
Navigation controller HG G-73650 (optional)
