Operating Manual HG G-98830YA | English, Revision 02 | Date: 21.06.2021
57
Configuration of the System via the Service Interface – Chapter 10
Figure 26
Menu: (T)ime & Code
Setting the threshold for generating the RX_NOISE bit
Use the
(B)Level to Noise Error
parameter to set the threshold mentioned in Table 28
on page 51 under
Noise
for generating the
RX_NOISE
bit in the system status word:
Value range:
0 … 1000
To set the threshold for generating the RX_NOISE bit:
Press the key
and enter the desired value.
Selection of the reception channel for code transmission
With the
(S)elect Code Channel
parameter, you define which of the two available re
-
ception channels is used for code transmission. As a rule, this is the reference chan
-
nel S. However, it is also possible to select the positioning channel to minimize inter
-
ference.
If you use the positioning channel, the code is dropped in the middle (at x ≈ 0) in a
narrowly defined area! The error counter
N
and the noise counter increase, the bit
Noise
and
wrong Codeparity
in the system status are set.
Selection:
S = The reference channel S is selected.
P = The positioning channel D for minimization of interferences is selected.
To select the reception channel for code transmission:
Press the key
and enter the desired value.
S:0006 D:+006 D_X:+32767 D_Y:+32767 Code: 00000001 Read: 73:
N: 0
Frx[/Hz]:66800 Ftx[/Hz]:127980
U[/mV]:24000 I[/mA]: 270 T[Grd.C]:+33 E: 0000 Noise 0
(B)Level to Noise Error [0..1000]: 1000
(S)elect Code Channel S
(H)igh-Nibble of RW-Code [0..F,>F]: 10
(N)umber of equal Codes [0..15]: 1
(T)hreshold for Decoding [20.1023]: 256
PosiPulse (a)fter Decoding 1
(L)evel for Positioning/Calculation [20.1023]: 256
(P)osi-Pulse Time [n*1ms]: 100
(O)ne Positioning Pulse per Crossing 0
(X) Timed Positioning Pulse 1
(C)CODE_OK -> POSI_OUT 1
Th(r)eshold MAX-Detection [10.1023]: 400
(Q)uit Menue
