Operating Manual HG G-98830YA | English, Revision 02 | Date: 21.06.2021
55
Configuration of the System via the Service Interface – Chapter 10
Figure 25
Output at (D)isplay Telegram Content
To return to the menu
Serial Output
:
Press any key.
Setting character delay time (3964R)/timeout-time (transparent)
The parameter
(C)har Delaytime
is the so-called character delay time for the proce
-
dure
3964R
(see 16.2 „Procedure 3964R“ on page 87) and the timeout time for in
-
coming characters for the procedure
transparent
(see 16.3 „Procedure transparent“
on page 88).
Value range:
1 … 220 ms
To set the character delay time or the timeout time:
Press the key
and enter the desired value.
Setting the acknowledgment delay time
If you use the procedure
3964R
, youalso set the parameter
(A)ck-Delaytime
:
Value range:
1 … 1680 ms
To adjust the acknowledgment delay time:
Press the key
and enter the desired value.
Setting the output type
With the parameter
Conti(n)ous Telegrams
you determine whether data is sent per
-
manently or only after a transponder has been detected:
Selection:
0 = Output only occurs when a transponder is decoded in the field
1 = The output is permanent according to the set (S)
erial Data Period
S:0006 D:+006 D_X:+32767 D_Y:+32767 Code: 00000001 Read: 42:
N: 0
Frx[/Hz]:66760 Ftx[/Hz]:127990
U[/mV]:24000 I[/mA]: 260 T[Grd.C]:+33 E: 0000 Noise 0
STX 1 Bytes from Position: 1
Delta_Y 2 Bytes from Position: 2
Delta_X 2 Bytes from Position: 4
CODE 4 Bytes from Position: 6
Usum 2 Bytes from Position: 10
Udif 2 Bytes from Position: 12
Vcc 1 Bytes from Position: 14
Current 1 Bytes from Position: 15
Temp. 1 Bytes from Position: 16
CodesRd 1 Bytes from Position: 17
Rx-Freq 2 Bytes from Position: 18
Tx-Freq 2 Bytes from Position: 20
STATUS 2 Bytes from Position: 22
(Q)uit Menue
