Gotting HG G-98820ZA, Technical Description

Page: 19 / 74

Components and Operation
HG G-98820ZA
English, Revision 09, Date: 13.12.2016 19
In the following table you will find a list of the binary codes used to describe the system
status (for byte # 20 and 21 in Table 4):
*) These bits are deleted as soon as the Transponder leaves the
Antenna reception range.
Example:
System status
0x0014
means EEPROM_ERROR and RX_NOISE.
This status message
0x0002
may also occur during an ordinary transponder cross-
ing, if the code transmission is aborted due to decreasing output level.
Value Name Description
0x0001 DEC_HW_ERROR code decoder hardware error
0x0002 CODE_PAR_ERR reception of transponder code with parity error or Hi-Nibble
received
0x0004 RX_NOISE Set whenever TRANS_IN_FIELD was set but no codes
were received
0x0008
0x0010 EEPROM_ERROR parameter E²Prom not addressable
0x0020 PARAM_CRC_ER parameter block not safe
0x0040 POT_ERROR IIC-Bus Potis not addressable
0x0080 F_ERROR Transmitting or receiving oscillator not tuned to the set fre-
quency
0x0100 ESTIMATE If the exact Transponder Position cannot be determined
due to wrong reading distances or e. g. steel reinforce-
ments in the ground, an estimated value with the accuracy
of ±10 mm is determined and this bit is set
0x0200 TRANS_IN_FIELD transponder is being detected *)
0x0400 CODE_OK Code decoded without errors *)
0x0800 SEGMENT The transponder is located within the area marked -X in
Figure 4 on page 7 *)
0x1000 POSIPULS Transponder has crossed the Antenna center
0x2000
0x4000
0x8000
Table 5
Possible system status messages