Software
English, Revision 06, Date: 14.12.2016
37
allows to turn the Profibus on or off. When switched on it is initialized with the Slave
address as specified with
.
With
you can choose whether the highest byte is output first or last (see Table 13
Leave this menu with
to return to the main menu. Remember to save changed pa-
rameters.
5.2.2.7
(W)rite Transponder
After opening this mode, enter an up to 5-digit Hex code. Locate an RW transponder
type 70652ZA in the rated distance of the antenna field and activate the programma-
tion with
.
5.2.2.8
CS(V)
For means of diagnosis generating output of the values
Code
,
DELTA_X
,
DELTA_Y
as
well as the status messages
Transponder within field
,
Code OK
and a protocol
counter in
CSV Format
(Comma Separated Values; a text file especially formatted to
be read by spreadsheet analysis programs) is possible. This output is continuous at
38.400 baud, 8 bit and even parity, until it is interrupted by hitting the
key. This key-
stroke generates a reset of the antenna to the basic settings (not monitor mode) includ-
ing the stored parameters.
Storing the CSV output is, e.g., possible using the program HyperTerminal® (also refer
to section 5.1 on page 25). Use the function
Text aufzeichnen ...
of menu
Über-
tragung
and insert an appropriate file name (should bear the file ending
.csv
in or-
der to ensure that the spreadsheet calculation program will automatically recognize
this file). Once the file is recorded, stored and closed under HyperTerminal®, it may
be uploaded into a spreadsheet calculation program (e. g. Microsoft® Excel®, Sun®
StarCalc®, ...).
When opening the file various options will be prompted by the spreadsheet calculation
program. Make sure to state that the file consists of Comma Separated Values. Then it
is possible to process the data for the generation of diagrams or save it as native
spreadsheet calculation file.
5.2.2.9
(U)pdate firmware
This menu offers the possibility to proceed a software update without disconnecting
the power supply of the device. First the update programm has to be installed as ex-
plained in chapter 5.3.1 on page 38.
Press B in the main menu. Then a picture showing the following instructions appears:
1.
Open the Flash program.
2.
Select the COM port by which the antenna is conncted to the PC.
3.
Select the HEX file, which is up to be programmed.
4.
Go back to Hyperterm and press any key.
5.
Close the COM port in Hyperterm within the next 20 seconds, then change to
the HEX flasher and run the programming.
