76343/4/5 | English, Revision 05 | Date: 23.02.2022
30
Chapter 4 – MC-Config Program
4.6 Firmware-Updates
After pressing the Upgrade button the user is led to a dialog, where a firmware file
can be selected. Firmware files for WLAN clients are of the type
bin
. The selected file
is subsequently transferred to the WLAN client and stored in its flash memory. The
existing configuration of the WLAN client is being taken over and applied to the new
firmware.
4.7 Search WLAN Clients
4.7.1 IP Ranges
The following conditions might be the reason that the MC-Config program cannot
establish a connection to WLAN clients:
The WLAN clients are in a different network.
The WLAN clients are connected via a WLAN infrastructure that does not for
-
ward the broadcast queries of the MC-Config program.
In order to reach these WLAN clients you can define IP ranges that are scanned with
the start of the MC-Config program or after pressing the Refresh button. The dialog
for defining the IP ranges can be opened here:
Figure 22
MC-Config Program: IP Ranges
Table 16
MC-Config Program: Buttons of the Config dialog
Number
Button
Function
7
Break
Closes the Config dialog without transferring the
changes to the WLAN client.
8
Apply
Starts the transfer of the parameter set to the WLAN
client. The Config dialog is closed.
9
Save to file
Saves the current parameter set in a file.
10
Load from file Loads a parameter set from a file.
11
Check
Transfer of the parameter set to the WLAN client for
verification. The result of the verification is shown in
the status bar at the bottom (12).
