76343/4/5 | English, Revision 05 | Date: 23.02.2022
16
Chapter 3 – Commissioning
application is described in chapter 4 on page 17 (including the further com
-
missioning steps).
The MC-Config program, when it‘s connected, shows an SNR
value that is an indication for the quality of the connection:
Signal
40
Very good connection
Signal
30
Good connection
Signal
20
Connection just sufficient
Signal < 20
Connection impaired,
Bit rates are reduced in order to transfer data
3.4 Reset to Factory Settings
By pressing the
Reset
button for a long time, the HG G
76343/4/5 can be set back
to its factory settings. When keeping the reset button pressed, the radio modem
goes through different sequences that are visualized by all four LEDs lighting up in
the same color.
The LED-sequences start with lighting up in white, then blue
red
green; re
-
starting with white. Holding the
Reset
button pressed after the third time the all LEDs
light up blue, the device is set back to its factory settings. All LEDs are off during the
reset to factory settings. After that, the
Reset
button can be released. When the
Re
-
set
button is released before the factory reset was initiated, then the HG G
4/5 needs to be restarted by briefly pressing the
Reset
button again.
The HG G
76343/4/5 has the following (important) factory settings (device name ac
-
cording to variant):
Device Name: "HG76343"
SSID = "DefaultWLAN"
Encryption mode = no encryption
MODE= 802.11b/g/n
IP = 192.168.170.100
Netmask = "255.255.255.0"
Gateway = 192.168.170.1
user = "" (leer)
password = "" (leer)
SER1: inaktiv
Relais: inaktiv
Input: inaktiv
