Gotting HG G-19334, Manual

Page: 7 / 33

Device Description
HG G-19334-A
English, Revision 03, Date: 11.05.2017 7
2.3 LEDs on the Front Plate
Figure 3
LEDs
On the front plate you can find two LEDs per antenna system (red + green) that indi-
cate the zero crossing point of the difference signal (both LEDs are lit at once). In ad-
dition to those you can find one LED that indicates sufficient power supply (Power) and
a LED that indicates CAN communication:
2.4 Pin Allocations
Depending on the version of the guidance antenna (see Table 1 on page 4) the circular
connectors are placed on the top resp. the back side of the casing. The following in-
terfaces are available.
Figure 4
Placement of the circular connectors
CAN - Is lit continuously in the state „operational“
- Blinks in the state „pre-operational“
- Flashes in the state „stopped“
- Stays dark in case of CAN bus errors
Table 2
Dsiplay options of the CAN LED
Power
CAN
R R
L
R L L
H
L
SYSTEM 3 SYSTEM 2 SYSTEM 1
NODE-ID
HG 19334-A
INDUCTIVE GUIDANCE SENSOR
GÖTTING KG
Celler Str. 5, D-31275 Lehrte
ST1
M12x1 circular connector
5-pin (male)
A-coded ST2
M12x1 circular connector
5-pin (female)
A-coded ST3
M12x1 circular connector
5-pin (male)
A-coded
Power