Device Description HG G-193x0-B | English, Revision 02 | Date: 07.05.2018
20
Chapter 6 – Configuration
6.4 Service Program
When the connection inside the Terminal Program (see above) is successfully established
press any key to make the following main menu appear.
6.4.1 Main Menu
The main menu differs for the sensor versions. For version HG G-193x0ZB an additional
CAN menu is available. The main menu always shows the five guide wire frequencies and
the frequency of the energy track as well as the corresponding actual sum and difference
values.
6.4.1.1 HG G-193x0ZB (CAN)
Figure 10
HG G-193x0ZB (CAN): Main menu
6.4.1.2 HG G-193x0YB (Profinet)
Figure 11
HG G-193x0YB (Profinet): Main menu
•
Frequency config, s. section 6.4.2 on page 21
•
Calibration config, s. section 6.4.3 on page 21
•
Encoder config, s. section 6.4.4 on page 22
•
CSV, s. section 6.4.5 on page 23
•
CAN config, s. section 6.4.6 on page 24 (only visible for version HG G-193x0ZB)
HG 19370 ZB V1.01 Main menu Goetting KG
Frequencies: 5000 6000 7000 8000 10000 25000
Sum: 0 0 0 0 358 0
Dif: 0 0 0 0 0 0
Encoder: 0
1: Frequency config
2: Calibration config
3: Encoder config
4: Serial Data-Stream
5: CAN config
U: Firmware Update
HG 19370 YB V1.01 Main menu Goetting KG
Frequencies: 5000 6000 7000 8000 10000 25000
Sum: 0 0 0 0 358 0
Dif: 0 0 0 0 0 0
Encoder: 0
1: Frequency config
2: Calibration config
3: Encoder config
4: Serial Data-Stream
U: Firmware Update
