Software
English, Revision 04, Date: 19.01.2015
45
Figure 26
Update program: Operating Elements
Start the programming process by switching on the antenna and then click
Program
within a period of 10 seconds afterwards. A device reset follows and after a short pe-
riod of time, the file is being transmitted.
Figure 27
Update program: programming procedure
Once the programming process is completed, the program can be closed (
close
).
The interpreter is restarted automatically and uses the new program.
2 Selection of the serial interface
1 Selection of the Hex file to be
5 Status messages
4 Start the programming procedure
6 Exit the program
transmitted
3 This option must always be
activated
and baud rate (max 57600 Baud)
If an error occurs during the transmis-
sion, red colored status messages are
shown. As long as green colored mes-
sages are output, the software update
is correct.
The last 2 messages of a normal up-
date procedure are:
ProgramFlash:
Ok
and
CloseCom: Ok
