Software
English, Revision 02, Date: 20.01.2015
23
4
Software
Transponder Programming and Update of the Internal Software
For the realization of these requirements the reader G 71450-A has to be set to the
monitor mode, i. e. connect the serial interface of a PC / laptop with the appropriate
pins (Rx and Tx, see table Table 1 auf Seite 9) of the reading device. Then start the
terminal program (see below). The interface parameters have to correspond to those
parameters — adjusted by DIP switches — of the reading device (see Table 3 auf Seite
11).
4.1
Terminal program
In the following we refer to the program
HyperTerminal
®
(
Hypertrm.exe
) which is
part of the scope of supply of Microsoft
®
Windows
®
. We apply this program because
many operators use it. Due to the configuration files we supply, it is user-optimized. It
is possible to download the latest version of these files under the following address
tp://www.goetting.de/en/download/
. Enter search term
7145
to find the files for each
single reading antenna (7145x.zip; 7145xxxx.ht).
However, it is possible to apply any other terminal program, provided that it implies
ANSI emulation. Should you use a different program, please consider the documenta-
tion enclosed to this program and adjust it to the values indicated in section 4.1.2.
Please continue on page 24 then.
4.1.1
Locate HyperTerminal / Add to the system
First make sure that HyperTerminal is installed on your system. If only the standard ver-
sion is available, you can easily add Hyper Terminal subsequently using your Windows
installation CD.
Open
System Control
(below in the illustration: Windows 95).
Figure 14
Adding HyperTerminal to your system
3.
Click on icon
Software.
Select the card index tab
Windows-Setup
in the
window
Properties of Software
Windows-Setup.
Then choose the point
connections
from the
components.
Click
