2
Power
Eco / Max
4”
(10cm)
8”
(20cm)
Keep this area
clear while in use
4”
(10cm)
2. Safety Guidelines
•
Do not use if the electronics or provided battery are submerged in water. Dry
out completely and test for functionality in a controlled environment if any
part of the Chill’s electronics or battery are submerged in water.
•
Verify power source voltage and amperage before using. Change battery
protection level as needed depending on power source.
•
Do not place electronics in the Chill when in operation.
•
Do not tilt past 45 degrees during transportation or 30 degrees during oper-
ation. If the Chill falls over or flips during transportation or operation, turn off
immediately and allow to rest for at least 12hrs before turning back on. Liquid
refrigerant may have gotten to the compressor, and you must allow it to
evaporate before turning back on. The compressor is designed for evaporat-
ed refrigerant only, liquid refrigerant can cause immediate and permanent
compressor damage.
•
Do not operate the Chill next to a heat source (stove or heater), avoid oper-
ating the Chill in direct sunlight if possible.
•
The cooler area of the Chill can hold water. To drain any water from the Chill,
use the drainage plug in the bottom of the unit. DO NOT POUR WATER OUT
OF THE CHILL FROM THE LID, this will potentially allow liquid refrigerant to
reach the compressor and you will need to wait 12 hrs before using the chill
again while you wait for the refrigerant to fully evaporate.
•
We recommend you clean the Chill’s interior before first use. Use a damp
cloth with mild soapy water.
•
Never use harsh cleaners with the GoSun Chill. Only use a damp cloth with
mild soapy water. Do not use a hose to clean the outside of the Chill as water
may get into the compressor and electronics section of the unit.
•
Clean and dry the inside of the Chill after each use. If storing for more than
24hrs, we recommend you partially open the lid during storage.
•
The GoSun Chill is not designed as a seat, do not stand or sit on the Chill.
•
Ensure the Chill has proper ventilation to the compressor chamber. Leave
space to the front, back, and side of the Chill as shown in the diagram below.
▪ Front: 4” (10cm) ▪ Back: 8” (20cm) ▪ Side: 4” (10cm)