Gossen MetraWatt B100B, Operating Instructions Manual, Page: 39 / 60

37
Gossen Metrawatt GmbH
METRACELL BT PRO
10.5 Charge Measurement
With the help of the CHARGE measuring function, the voltages of the blocks of a battery can be measured several times at short intervals
while charging (capacity test of the blocks).
Note
At least two test runs must be completed for the charge measurement.
Note
Polarity can be switched off


28. If polarity is switched off, the absolute value of the measured value is recorded.
Se-
quence
Description of the Measurement Display
1 Connect the multimeter test probe measurement cables to the P–/COM and S+ sockets with
the matching colors (

“Measurement Inputs”

5).
2 Press and hold the FUNCTION key for about 2 seconds in order to switch the battery tester on. BTpro <date>
<version> <time>
3 Press any key to open the main menu .
If you’re already in another menu, press the FUNCTION key repeatedly until the main menu ap-
pears.
-> MEASUREMENT
DATA
4 Press the OK key in order to open the MEASUREMENTS menu.
The MEASUREMENTS menu is displayed.
-> MULTIMETER
FLOAT
5 Select

CHARGE using the
▼ ▲
keys. DISCHARGE
-> CHARGE
6 Press the OK key in order to open the selected menu for the measuring function. -> START
SELECT.BATT
7 Before starting the measurement, the location, battery and limit value parameters must be set.
These can be:
–
Selected in the battery database via RFID

step 7a.
– Selected manually in the battery database

step 7b.
– Entered manually at the battery tester

step 7c.
START
-> SELECT.BATT
7a

A battery database has been created
 
18.

The battery database has been transferred to the battery tester
 
18.

You use RFID technology for your system.

The DUTs in the battery database are linked to the corresponding RFID tags
 
24.
1. Select

SELECT.BATT with the
▼
key.
2. Press the OK key
The battery database is displayed. An acoustic signal indicates that the RFID reader is
ready.
3. Read the RFID tag (
 
5).
An acoustic signal confirms reading and the DUT is displayed.
4. Press the OK key.

The battery is selected. The battery tester returns to the MEASUREMENTS menu.
START
-> SELECT.BATT
7b

A battery database has been created


18.

The battery database has been transferred to the battery tester


18.
1. Select

SELECT.BATT with the
▼
key.
2. Press the OK key
The battery database is displayed. An acoustic signal indicates that the RFID reader is
ready.
3. Select a battery using the
▼ ▲
keys.
4. Press the OK key.

The battery is selected and the battery tester returns to the MEASUREMENTS menu.
START
-> SELECT.BATT
7c 1. Select the AREA:XXXX. parameter with the
▼
key.
2. Press the OK key.
The entry mode is active.
3. Enter the parameter’s first digit
 
5.
4. Acknowledge your entry with the OK key.
5. Repeat steps 1 through 4 for all other parameter digits for battery number, number of
blocks and upper and lower voltage limit values.
SELECT.BATT
-> AREA : 0 000
8 Return to START using the
▲
key. -> START
SELECT.BATT
9 Press the OK key in order to start the measurement. BLOCK - - - - - - -
XXXX/X
AN:XXXX BN:XXXX