8
Repair and Maintenance
WARNING:
Turn the power switch “OFF” before conducting any maintenance procedures.
Adjusting the Brakes
Tools required:10mm wrench
1. To adjust the brake cable thread
clockwise (loosen) or counter
clockwise (tighten) the adjuster barrel
on the brake lever. Only turn the
barrel in small increments until the
desired adjustment is reached. If
brake continues to need further
adjustment proceed to the next step.
2. If the brake cable is still either too
tight or too loose use a 10mm wrench
to loosen the brake cable pinch bolt
for further adjustment on the cable.
Ensure that the 10mm nut is securely
tightened after the adjustment is
made.
WARNING:
The brake could be capable of locking up and skidding the rear wheel if not applied correctly.
Always try and avoid skidding as this could cause you to lose control of the scooter and will cause damage to
the rear tire. Practice using the brake in an unobstructed open area to become familiar with its function and
can make smooth controlled stops.
