SUPER T SERIES
OM-07207
PAGE B - 1
INSTALLATION
INSTALLATION - SECTION B
Review all SAFETY information in Section A.
Since pump installations are seldom identical, this
section offers only general recommendations and
practices required to inspect, position, and ar
range the pump and piping.
Most of the information pertains to a standard
static lift
application where the pump is positioned
above the free level of liquid to be pumped.
If installed in a
flooded suction application
where
the liquid is supplied to the pump under pressure,
some of the information such as mounting, line
configuration, and priming must be tailored to the
specific application. Since the pressure supplied
to the pump is critical to performance and safety,
be sure
to limit the incoming pressure to 50% of the
maximum permissible operating pressure as
shown on the pump performance curve.
For further assistance, contact your Gorman‐Rupp
distributor or the Gorman‐Rupp Company.
Pump Dimensions
See Figure 1 for the approximate physical dimen
sions of this pump.
OUTLINE DRAWING
.69/[17,5] DIA
7 HOLES EACH SIDE
.69/[17,5] DIA
4 HOLES
SUCTION:
6.00
−
8 NPT
DISCHARGE:
6.00
−
8 NPT
POWERED BY: ISUZU 4LE2X DIESEL ENGINE
95.50
[ 2425,7 ]
104.00
[ 2641,6 ]
12.00
[ 304,8 ]
2.75
[ 69,8 ]
75.50
[ 1917,7 ]
44.25
[ 1124,0 ]
51.00
[ 1295,4 ]
29.50
[ 749,3 ]
14.75
[ 374,6 ]
5.50
[ 139,7 ]
2.75
[ 69,8 ]
48.85
[ 1240,7 ]
APPROX. 36.25
[ 920,7 ]
5.13
[ 130,3 ]
10.54
[ 267,6 ]
.75
[ 19,0 ]
14.00
[ 355,6 ]
2.75
[ 69,8 ] TYP
5.19
[ 131,9 ]
23.75
[ 603,2 ]
Figure 1. Pump Model T6A60S-4LE2X FT4
PREINSTALLATION INSPECTION
The pump assembly was inspected and tested be
fore shipment from the factory. Before installation,
inspect the pump for damage which may have oc
curred during shipment. Check as follows:
a. Inspect the pump assembly for cracks, dents,
damaged threads, and other obvious dam
age.
b. Check for and tighten loose attaching hard
ware. Since gaskets tend to shrink after dry
