7
2)
Attach the two curved bars to the
horizontal plastic bar using the medium
bolts (11), washers (13), locking
washers* (20), and nuts (14).
Don’t
over-tighten because it is just plastic.
Make sure the head (square base) of
each bolt goes on the padded side of
the plastic bar.
3) Connect the two curved bars (1) to
the Main Support Bar using the Long
Bolts (12). The curved bars (1) should
be nested in the plastic stabilizers (8) on
the main support bar (3,4).
Use the Long Bolts (12) to connect all three
of these surfaces together with the head
square base of the bolt threaded through
underneath so the square hole matches
with the square base of the bolt. Then use
the washers (13), nuts (14), and locking
nuts (20) to finish the attachment
connection at the top. When finished, all the
nuts/washer end points should be facing
upward.
Note: You must match the head (square
base) of the Long Bolts (12) to the square
openings on the main support bar to ensure
proper fit.
