Gorenje X6012-17a, Instructions For Use Manual, Page: 16 / 260

14
Turn the hinge fastener tightly to the end.
Connect harness wirings and screw down the ground
wire.
Fasten the bending tube guide and insert the water
tube far into the coupling. (Dispenser Models Only)
Replacing Refrigerator Door
Insert the bottom hole of the refrigerator
door straight into the bottom hinge pin.
Let the top of the door close and insert the top hinge
pin to the top hole of the refrigerator door.
(Insert the back of hinge to the groove of protrusion
first, then front to the top hole of door.)
Turn the hinge fastener tightly to the end.
Connect harness wirings (model dependent) and screw
down the ground wire. Click and screw the top hinge
cover.
Refrigerator Leveling &
Door Adjustment (If needed)
The refrigerator must be level in order to maintain optimal
performance and desirable front appearance.
(If the floor beneath the refrigerator is uneven, the freezer
and refrigerator doors may look unbalanced.)
In case freezer door is lower than
refrigerator door...
Insert a screw driver (flat
tip) into a groove of the left
wheel (bottom of freezer)
and turn it clockwise until the
door is balanced. (Clockwise
to raise freezer door,
counterclockwise to lower.)
※ If the freezer door is not balanced by step 1, then follow
the next steps.
Open the doors, unscrew the
front cover and remove, if it is
attached.
Insert a spanner (A part) into the hinge nut (1 part) and
unscrew the nut by turning clockwise.
Insert a spanner (B part) into the hinge nut (2 part)
and turn clockwise to lower the door.
If the door is aligned, fasten the nut (1) tightly by turning
counter-clockwise.
In case refrigerator door is lower than
freezer door...
Insert a screw driver (flat tip)
into a groove of the right
wheel (bottom of refrigerator)
and turn it clockwise until the
door is balanced. (Clockwise
to raise refrigerator door,
counterclockwise to lower.)
1
1
2
3
4
5
1
2
3
3
4