Instructions for Use
18
x
The reason may be inadequate ventilation
of the compressor and condenser (assure
adequate air circulation and wipe off the
condenser);
Ice Formation on the Inner Rear Wall
As long as the defrost water runs to the
channel and through the outlet to the drain
pan on the compressor, automatic defrosting
of the appliance is assured.
In case the ice formation on the inner back
wall is increased (3-5 mm), ice should be
manually defrosted.
Set the thermostat knob to
STOP (0)
position
and leave the door open. Never use electric
devices for defrosting and do not scrape the
ice or frost layer with sharp objects.
After completed defrosting, turn the knob to
desired position and close the refrigerator
door.
The cause of increased ice formation may be
one of the following:
the door does not seal well (clean the
gasket if it is contaminated, or replace it if
it is damaged);
the door was frequently opened or it was
left opened for too long;
the food stored in the refrigerator was
warm;
the food or dish is touching the inner back
wall.
Water is Leaking From the Refrigerator
In case the discharge water outlet is clogged,
or the defrost water drips over the channel,
water leaks from the refrigerator.
x
Clean the clogged outlet, for example with a
plastic straw.
x
Manually defrost the increased ice layer.
See Ice Formation on the Inner Rear Wall.
Noise
Cooling in refrigerating-freezing appliances is
enabled by the refrigerating system with
compressor, which produces noise. How
noisy the appliance is depends on where it is
placed, how it is used and how old the
appliance is.
x
During the operation
of the compressor
the noise of liquid is heard and when the
compressor is not operating, the refrigerant
flow is heard. This is a normal condition and
it has no influence whatsoever on the
lifetime of the appliance.
x
After starting the appliance
, the operation
of the compressor and the refrigerant flow
may be louder, which does not mean that
something is wrong with the appliance and it
has no influence on the lifetime of the
appliance. Gradually the noise is reduced.
x
Sometimes
unusual and stronger noise
is
heard, which is rather unusual for the
appliance. This noise is often a
consequence of inadequate placing.
The appliance shall be placed and levelled
firmly on solid base.
It should not touch the wall or kitchen units
standing next to it.
Check the accesories in the interior of the
appliance, they should be placed correctly
in their positions; also check the bottles,
tins and other vessels that might touch
each other and rattle.
Bulb Replacement
Before replacing the light bulb, disconnect the
appliance form the power supply.
Press the cover at the rear side (in the arrow
1 direction) and remove the plastic cover (in
the arrow 2 direction). Replace the bulb with a
new one (E14, max. 15 W).
Don't forget: the old bulb does not belong to
organic waste.
Light bulb is consuming good therefore
our in-guarantee service does not relate to
it.
Bulb lamps used in this appliance are special
purpose lamps selected for household
appliances use only. They are not suitable for
household room illumination.
WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO INFLUENCE ON THE
OPERATION OF THE APPLIANCE.