Gorenje GS66260, Operating Instructions Manual

Page: 30 / 36

Placing the dishwasher
The dishwasher is intended for
freestanding installation, but can also be
installed under a worktop.
Adjust the height and slide the
dishwasher into place
24 mm
Freestanding
1. Make sure the area on which the
dishwasher is to be installed is firm.
Adjust the dishwasher's height using
the four feet so that the dishwasher is
level. The dishwasher may lean no
more than 5 mm.
2. Once the feet are properly adjusted,
tighten the anti-tip feet firmly against
the floor.
Anti-tip feet
Built-in
1. Start by measuring the height from the
floor to the bottom edge of the worktop.
2. Measure the height from the floor to the
top edge of the dishwasher.
3. Adjust the front feet by turning them
clockwise to raise and anticlockwise to
lower the dishwasher.
Lean the dishwasher forwards a little
and adjust the rear foot with the screw
at the front of the dishwasher. Turn
clockwise to lower or anticlockwise to
raise.
4. Check that there is an air gap of at least
3 mm between the underside of the
worktop and the top edge of the
dishwasher.
5. Slide the dishwasher into place.
• Pull through the drainage and supply
hoses when the machine is slid into
place.
• Check that the hoses have no kinks
or sharp bends, and check that there
is nothing that can damage the
hoses.
• Check that the machine is installed
such that the door opens freely,
otherwise door lock functionality may
be disrupted.
6. Make any final adjustments to the front
feet (the dishwasher may lean no more
than 5 mm).
7. Once the feet are properly adjusted,
tighten the anti-tip feet firmly against
the floor.
The dishwasher can also be installed in a
recess without its worktop. See Remove
dishwasher worktop.
30