Troubleshooting
Action
Type of fault on the display
Clear the drainage pump. See the section Care and cleaning. If the problem
persists, call the service department.
Overfilling
F10
See “Water remains in the dishwasher” in the table “Problem” below. If the problem
persists, call the service department.
Water Outlet Fault
F11
Check that the water tap is on. Check that the outer filter on the inlet hose is not
blocked. If the problem persists, call the service department.
Water Inlet Fault
F12
Turn off the water tap and call the service department.
Inlet Valve Leakage
F40
Check that the outer filter on the inlet hose is not blocked. Also check that the
drainage hose is fitted in accordance with the installation instructions. If the problem
persists, call the service department.
Water Level Fault
F52
Check that the filters are not blocked. Restart the dishwasher. If the problem
persists, call the service department.
Circulation Fault
F53
Turn off the water tap and call the service department.
Overfilling
F54
Call the service department.
Circulation Fault
F56
Press any button to clear the error message.
Action
Possible causes
Problem
Wait a moment then try again.
You have pressed the buttons too soon
after opening the door.
The buttons do not react when pressed.
Clean with a dry or slightly damp cloth.
The buttons are dirty.
Open the door. The buttons only react
to use when the door is open.
The door is closed.
Check that the baskets are correctly
positioned horizontally.
The baskets are not correctly positioned.
Cannot close door.
Check that the dishes are not blocking
the baskets from sliding properly into
place.
Check the door lock. If it does not click
into place and lock, open the door. Press
and hold the button for the Auto open
option for 15 seconds. Then wait 30
seconds. Close the door. Check that the
door lock clicks into place and locks.
The door lock does not click into place
and lock.
13
