Gorenje GDV642XL A, Operating Instructions Manual

Page: 69 / 144

Drainage connection
See the separate installation instructions for all
necessary information.
This dishwasher is suitable for installing in a raised
recess (to attain an ergonomic working height). This
means that the dishwasher can be placed so that
the drainage hose runs to a lower level than the
bottom of the dishwasher, such as by routing it
directly to a floor drain. The dishwasher is fitted with
an integrated anti-siphon device to prevent the
machine from being emptied of water during the
wash cycle.
The drainage hose can also be connected to a
connection nipple on the sink unit's water trap. The
connection nipple must have an internal diameter
of at least 14 mm.
The drainage hose may be extended by a maximum
of 3 m (the total length of the drainage hose must
not exceed 4,5 m). Any joins and connecting pipes
must have an internal diameter of at least 14 mm.
However, the drainage hose should ideally be
replaced with a new hose without joins.
No part of the drainage hose may be more than 950
mm above the bottom of the dishwasher.
Ensure that the drainage hose has no kinks.
Connection to water supply
Use only the supply hose provided with the
dishwasher. Do not re-use old hoses or other spare
supply hoses.
The supply pipe must be fitted with a stopcock. The
stopcock must be easily accessible, so that the water
can be shut off if the dishwasher has to be moved.
Once the installation is complete, the stopcock
should be opened to allow the pressure to settle for
a while and to check that all connections are tight.
Connect to cold water...
If you use oil or electricity to heat your home.
Connect to hot water (max. 70 °C)...
If you use district heating, solar power or geothermal
power to heat your home. Choosing a hot water
connection cuts programme times and reduces the
dishwasher's electricity consumption.
Electrical connection
Information about the electrical connection can be
found on the serial number plate This specification
must match the electricity supply.
Dishwashers fitted with a plug must be connected
to an earthed socket.
The electric wall socket must be placed outside of
the installation area to be easily accessible after
installing the dishwasher. Do not use an extension
cord!
NOTE!
Repairs and maintenance relating to safety or
performance must be carried out by a qualified
professional.
English 69
Installation