CARE AND CLEANING
COARSE FILTER
The coarse filter traps larger food particles, which
cannot get past the drainage pump. Empty the
coarse filter as necessary.
1 Lift the coarse filter by the handle.
2 Empty the coarse filter. Remember to replace
it!
Coarse filter
FINE FILTER
Debris that collects on the fine filter is
automatically rinsed away during each wash.
However, the fine filter and its pipe section should
be cleaned a couple of times a year.
1 Turn the handle anticlockwise once.
1x
Fine filter
2 Lift the pipe section straight up by the handle.
Free the coarse filter to clean the pipe section.
3 Remove and clean the fine filter.
4 Replace in reverse order. Check that the edges
seal properly when replacing the fine filter.
Pipe section
5 Lock the filter in place by turning the handle
clockwise to the stop position. The handle
should point straight out from the dishwasher.
1x
NOTE!
The dishwasher must not be used without the
filters in place!
Dishwashing results may be affected if the
coarse filter is incorrectly fitted.
DRAINAGE PUMP
The pump can be accessed from inside the
dishwasher.
1 Cut the power to the dishwasher by pulling
out the plug from the wall socket!
2 Remove the coarse filter and pipe section.
3 Remove the small yellow fitted piece at the
left of the bottom drain (see illustration
below).
4 By inserting your finger into the hole you can
turn the pump blade to release anything
blocking it.
5 Reinstall the fitted piece and filters.
6 Plug the machine in again.
If the dishwasher still does not start and a
whirring sound is heard, the overflow
protection has been activated.
17
