Gorenje Plus GDV642X, Operating Instructions Manual

Page: 95 / 200

Action Type of fault Display
Call the service division. Overfilling
See "Water remains in the dishwasher" in the
table below. Water outlet fault
Check that the water tap is on. Water inlet fault
Turn off the water tap and call the service divi-
sion. Inlet valve leakage
Turn off the machine with the main power switch and then turn it on again to clear the error message from the display.
Action Possible causes Problem
Remove the arms and clean them. The spray arms do not rotate. The dishes are not clean.
Check that the dishes are not blocking
the spray arms.
Avoid large packages. Old detergent. Detergent is a perish-
able product.
Dose according to water hardness.
Far too much or far too little detergent
results in poorer dishwashing results. Incorrect detergent dosage.
Select a higher temperature or a more
powerful programme. Dishwashing programme too weak.
Do not cover porcelain with large
bowls or the like. Avoid placing very
tall glasses in the corners of the bas-
kets. Dishes loaded incorrectly.
Place dishes to sit steady. Glasses and cups have toppled over
during the programme.
Screw the filter firmly into place. See
the section Care and cleaning. The filter is not correctly fitted.
Check that the salt compartment lid is
properly tightened. Otherwise call the
service division. The water softener is leaking salt. Spots or films on the dishes.
See the section Settings. Incorrect water softener setting.
See the sections Rinse aid and Set-
tings. Incorrect rinse aid dosage setting.
Top up with salt. See the section Salt. Salt compartment empty.
Wash crystal at a low temperature and
with a conservative amount of deter-
gent. Contact the detergent manufac-
turer. Too high temperature and/or too much
detergent can cause etching on crys-
tal. Unfortunately, this cannot be re-
paired, only prevented.
Reduce the amount. See the sections
Rinse aid and Settings. If you have
very soft water, you may want to dilute
the rinse aid 50:50 with water. Rinse aid dosage setting too high. The dishes have a sticky white/blue
film.
English 95
Troubleshooting