Hardware
basicCON 4121 – User Manual
2-55
The MAX9260 interface module is a Grabber module supporting the
GMSL standard (Gigabit Multimedia Serial Link).
It includes the MAX9260 receiver of Maxim Integrated
and a MAX9259
transmitter for routing through.
The module has a second connection and appropriate circuitry,
enabling not only signal receiving, but also routing through.
By this, the Grabber module can be inserted into an existing system of
transmitter and receiver without changing the system itself.
The module has the following characteristics:
24 bits or 32 bits transmission (colors and control signals)
Resolution 1280x768 at most
Pixel clock frequency up to 104 MHz at 24 bits transmission
UART or I2C interface
The module includes two “D4S20D-40ML5-Z” type connectors of
Rosenberger, whereof the “Input” connector receives the signals,
while the “Output” connector routes the signals through.
The following table shows the assignment of the “Input” connector:
Pin
Signal
Annotation
1
Ground
Ground
2
SD_IN_P
Serial Data Input positive
3
Through_In_Out
Routed through
from “Input” to “Output”
4
SD_IN_N
Serial Data Input negative
The following table shows the assignment of the “Output” connector:
Pin
Signal
Annotation
1
SD_OUT_N
Serial Data Output negative
2
Through_In_Out
Routed through
from “Input” to “Output”
3
SD_OUT_P
Serial Data Output positive
4
Ground
Ground
The electrical signal properties correspond to the GMSL standard.
2.4.19
MAX9260