Installation and Warranty
1-2
basicCON 4121 – User Manual
Media Interface Modules
enable your
Video Dragon
to perform a
multitude of different Test tasks; and they are compatible to diverse
systems. Therefore it can be required to install a new
Media Interface
Module
for a new Test task.
Please make absolutely certain that all of the hardware installation
procedures described below are carried out with your system
switched off.
Please proceed as follows to change a
Media Interface Module
:
To remove an already installed module, loosen both knurled
screws (see figure below) completely. Then extract the module
from the
Video Dragon
by touching it at the knurled screws.
Plug the new module into the
Video Dragon
(within the guide
rails, that way that all labels have the same direction). Press
the module finally with a little power to the inside connector.
Then fasten manually both knurled screws.
1.2.2
Module
Change
Figure 1-1:
Module change