Gopel Electronic basicCON 4121 Video Dragon, User Manual, Page: 5 / 86

Installation and Warranty
basicCON 4121 – User Manual 1-1
1 Installation and Warranty
1.1 Scope of Delivery
The following parts belong to a delivery of your GOEPEL electronic
Video Dragon basicCON 4121
:

1x
Video Dragon
basic device

1x
Media Interface Module
(according to your order, already installed)

Power supply Unit

CD with Driver, Software and Manual

LAN cable

USB cable

Video cable
(the type depends on the installed
Media Interface Module
)
1.2 Hardware Installation
Having unpacked your
Video Dragon
completely, please check
whether the type of the
Media Interface Module
corresponds with your
order.
Then check if the module is fixed mounted at the
Video Dragon
.
Please make absolutely certain that all of the hardware installation
procedures described below are carried out with your system
switched off.
We recommend to install/ update the device driver software for USB
before connecting the
Video Dragon
to the PC/ Laptop
(see Driver Installation / USB ).
Hardware installation for
Video Dragon basicCON 4121
means only to
connect the attached power supply unit to the
Power
socket
(see Figure 2-4), and the USB or Ethernet cable to the control PC/
Laptop.
Please use the supplied USB cable to connect your Video Dragon to
the USB interface of the PC/ Laptop.
Other cables may be inapplicable.
Then, connect the
Media Interface Module
of the
Video Dragon
to the
device to be tested (the UUT).
All other connections are not required for video transmission.
Please use them only when needed.
Look for a description of these interfaces in chapter
Mainboard .
1.2.1 Connect the
Video Dragon