Required/ Nécessaire/ Obligatorio
Hardware kit* / Trousse de quincaillerie* /
Kit de aditamentos*
WARNINGS AND CAUTIONS
4PK 9-in LED 5CCT Plug-in Kit
(Page 1)
Kit de DEL enfichable de 23 cm / 9 po 5CCT, paquet de 4
(Page 3)
Kit LED enchufable de 9 pulgadas 5CCT, paquete de 4
(Página 5)
* Actual hardware may differ from illustration.
* La quincaillerie incluse peut être différente de l’illustration.
* Los aditamentos reales pueden diferir de los que se muestran en la ilustración.
IMPORTANT SAFETY INFORMATION
1. Use
ONLY
insulated staples or plastic ties to secure the cords.
2. Route and secure the cords so that they will not be pinched or damaged.
3. LED light output is strong enough to injure human eyes. Do
NOT
look directly at
exposed LEDs.
4. LEDs gradually emit less light over their lifetime.
5. Do
NOT
use with an extension cord, use
ONLY
with power strips that have integral
overcurrent protection.
6. Do
NOT
mount to surfaces less than ¼ in.
7. Do
NOT
mount over sinks or stoves.
8. Do
NOT
install these lights inside of enclosed cabinets.
9. Turn power off before servicing.
10. LED kit cannot be added onto as the plug-in driver is designed to work with a
maximum of 4 bars.
11.
NOT
intended for recessed installation in ceiling or soffits.
12. Suitable for
INDOOR
damp locations
ONLY
.
READ ENTIRE INSTALLATION PROCEDURE BEFORE YOU BEGIN!
CAUTION: DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT.
Model / Model / Modelo #: UC1306-WH1-09LFC-G
Diffuser
Diffuseur
Difusor
Wave/5CCT sensor switch
Contacteur de détection Wave/5CCT
Interruptor del sensor de ondas/5CCT
CCx9
CCx9
DDx16
BBx8
AAx8
(4)4in/ (2)12in/ (3)30in
(4)10,2cm/ (2)30,5cm/ (3)76,2cm
linking cord
Cordon de raccordement
Cable de enlace
Plug-in Driver
Support du luminaire
Bandeja de la lámpara
Easy Installation Command
®
Strips by 3M
DD
x16
1
2
NOTE:
Ensure mounting location is within 5ft. of an electrical outlet. Clean surface with rubbing alcohol. Remove red liners. Press two
strips to the back of the fixture on each end for 9" bar and one strip to the back of the sensor. Remove black liners. Press the fixture
and the sensor to surface with tab towards you. Press firmly for 30 sec.
Connect fixtures, wave/5CCT sensor switch, and plug-in driver by using the provided various sizes of linking cords. Use provided cord
clips where additional wire control is needed. Peel the backing off each clip and mount where required. Plug the Plug-in Driver into the
outlet.
1
2
seconds
30
REMOVAL
Gently hold the light or clip in place with one hand. Never pull the strip away from the surface! Always pull along the surface. Slowly stretch
each strip slowly against the surface at least 6 inches to release.
SLOWLY
This LED Light bar has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock. This plug will only fit in
a polarized outlet one way. If the plug does not fully fit in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use
power strip unless the plug can be fully inserted. Do not alter the plug.
