Required/ Nécessaire/ Obligatorio
Hardware kit* / Trousse de quincaillerie* /
Kit de aditamentos*
WARNINGS AND CAUTIONS
Add-On 9-in 5CCT LED Under Cabinet Light
(Page 1)
Luminaire additionnel 5CCT à DEL de 23 cm / 9 po pour éclairage en dessous d’un
meuble
(Page 3)
Luz LED 5CCT de 9 pulgadas añadible para debajo de gabinetes
(Página 5)
* Actual hardware may differ from illustration.
* La quincaillerie incluse peut être différente de l’illustration.
* Los aditamentos reales pueden diferir de los que se muestran en la ilustración.
READ ENTIRE INSTALLATION PROCEDURE BEFORE YOU BEGIN!
CAUTION: DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT.
Model / Model / Modelo #:
UC1271-WH1-09LF1-G
Diffuser
Diffuseur
Difusor
(1)12in
(1)30,5cm
linking cord
Cordon de raccordement
Cable de enlace
Easy Installation Command
®
Strips by 3M
CC
DD
1
2
Clean surface with rubbing alcohol. Remove red liner. Press two medium strips
(CC)
to the back of the fixture on each end for 9" bar.
Remove black liners. Press the fixture to surface with tab towards you. Press firmly for 30 sec.
Connect add-on bar onto the #UC1271-WH1-09LF3-G 3PK Starter Kit, for up to 6 bars total.Use provided cord clips
(DD)
where
additional wire control is needed. Peel the backing off each clip and mount where required.
1
2
seconds
30
REMOVAL
Slowly stretch each strip slowly against the surface at least 12 inches to release for the bar.
SLOWLY
IMPORTANT SAFETY INFORMATION
1. Use
ONLY
insulated staples or plastic ties to secure the cords.
2. Route and secure the cords so that they will not be pinched or damaged.
3. LED light output is strong enough to injure human eyes. Do
NOT
look directly at
exposed LEDs.
4. LEDs gradually emit less light over their lifetime.
5. Do
NOT
use with an extension cord, use
ONLY
with power strips that have integral
overcurrent protection.
6. Do
NOT
mount to surfaces less than ¼ in.
7.
A. For installation with Command
®
Strips by 3M:
Do
NOT
mount over sinks,
stoves, beds or inside of enclosed cabinets. Do
NOT
mount on wallpaper.
B. For installation using screws:
Do
NOT
mount over sinks, stoves, or inside of
enclosed cabinets.
8. Turn power off before servicing.
9. This add-on bar cannot be used on its own. It can only be used with the starter Kit
(Model#UC1271-WH1-09LF3-G). A maximum of 6 bars can be linked together.
10.
NOT
intended for recessed installation in ceiling or soffits.
11. Suitable for
INDOOR
damp locations
ONLY
.
AAx2
BBx4
CCx2
DDx2
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
w
all side
wall side
wall side
wall side
wall side
wall side
wall side
wall side
1. Verifique que el interruptor de la fuente de alimentación y de la
luz están en la posición de encendido.
2. Pruebe o reemplace el interruptor.
