Gomax Smart Vision, Quick Start Manual, Page: 5 / 12

5
Setting the IP Address
Each GoMax unit and Gocator sensor on the sensor system network must have a unique IP
address. By default, GoMax units are set to an IP address of 192.168.1.6. If this does not conflict with
other GoMax units or Gocator sensors on the network, you can skip this section.
To set the IP address of a GoMax unit, do the following:
1. Using an Ethernet cable, connect a computer to the ETH 1 port on the GoMax unit.
2. On the computer, launch an Internet browser and navigate to 192.168.1.6.
The GoMax web interface is displayed.