10
OPERATION SOFTWARE
System Requirement and Precautions
1. The MX-2000A provides a software control program which runs under Microsoft Windows 98, 2000,
XP through the interface of USB interface.
2. Before you click on the icon of the software, make sure you have secured the connection between
your computer COM port and the MX-2000A, also switched on the MX-2000A with green LED light.
3. The MX-2000A has remote control and software control. To make sure all information shown in the
software is synch
ronized with those in the device, please click “Connect” to acquire the latest data
from the MX-2000A after you press any key on the remote control.
Instruction of Software Connection
1. Power up the MX-2000A and you can see both red and green LEDs on the front panel blink. Make
sure the serial port USB connection secure.
2. The first step after running the software is to automatically detect if the device responses correctly
through USB port. The process takes 15-20 seconds. If the response is not accurate, a warning
window will show up as the figure below.
The possible reasons causing this failure could be:
●
The MX-2000A is not supplied with power or the MX-2000A enters deep sleep state. Please
check the current status, and reboot the MX-2000A.
●
The serial connection through USB is not well established or some other software has
taken the available serial ports. Please make sure the USB cable is well connected and the
available serial port is free to be used by the MX-2000A.
●
Com setting is not
correct. Please make sure that from Menu→ Connector→ Setting.
