GoMax Electronics SP-5105KC, User Manual

Page: 6 / 10

4
SWITCH SETTING
Left Position Right Position
SW1
EDID Learning Default EDID
SW2 HD Full HD
SW3 Audio
– 2 Channel
Audio - Multi Channel
SW4 2D 3D
EDID LEARNING
1. Power up the SP-5105KC. Connect to HDMI OUTPUT with the display you want the SP-5105KC to
learn its EDID.
2. To learn the display's EDID for source device connected to HDMI OUTPUT , Set SW1 to left Position.
Power on and wait for about 5 seconds to complete the EDID learning process.
HARDWARE INSTALLATION
Broadcasts HDMI signals to four remote displays with a local port
1. Turn off all devices, including sources and displays.
2. Connect an HDMI source (such as a Blu-ray Disc player) to the HDMI INPUT port.
3. Connect the receivers (CV-735 or CV-715s) via Cat-5/5e/6 cables to each HDMI Signal OUTPUT
port.
4. Connect the local HDMI equipped monitor.
5. Plug in 5V 4A DC power supply.
6. Power on the HDMI displays.
7. Power on the HDMI source device.
The instant switching enables only when the video and audio setting of the source has been
adjusted to "Auto" or "Pass-through"