FS 190
Operating instructions
- 5-
02821900988
5005967-04
2.1 Basic operation and designated use of the machine
The machine has been built in accordance with state-of-the-art standards and the recognized safety
rules. Nevertheless, its use may constitute a risk to life and limb of the user or of third parties, or cause
damage to the machine and to other material property.
The machine must only be used in technically perfect condition in accordance with its designated use
and the instructions set out in the operating manual, and only by safety-conscious persons who are
fully aware of the risks involved in operating the machine. Any functional disorders, especially those
affecting the safety of the machine, should therefore be rectified immediately.
Separation building implements are exclusively designed for sawing of abrasive building material at
buil
ding sites using tools in accordance with the manufacturer’s instruction.
Using the machine for purposes other than those mentioned above (such as for) is considered
contrary to its designated use. The manufacturer cannot be held liable for any damage resulting from
such use. The risk of such misuse lies entirely with the user. Operating the machine within the limits of
its designated use also involves observing the instructions set out in the operating manual and
complying with the inspection and maintenance directives.
2.2 Organizational measures
This operating manual must always be at hand at the place of use of the product and must be
accessible to the person operating the machine! In addition to this operating manual, all other
generally applicable legal and other mandatory regulations relevant to accident prevention and
environmental protection must be observed!
Such obligations may also comprise the handling of hazardous materials, provisioning and/ or wearing
of personal protective equipment, or road traffic regulations. This operating manual must be
supplemented by instructions covering the duties involved in supervising and notifying special
organizational features, such as job organization, work flows or the person entrusted with the work.
Person entrusted with work on the product must have read the operating manual prior to taking up
work. This applies especially to persons working only occasionally on the product, e.g. during set-up
or maintenance activities. Check - at least from time to time - whether the personnel is carrying out the
work in compliance with the operating manual and paying attention to risks and safety-relevant factors.
For reasons of safety, long hair must be tied back or otherwise secured, garments must be close-
fitting and no jewellery - including rings - may be worn. Severe injury may result from being caught by
moving parts of the machine.
Personal protective equipment must be used wherever required by the circumstances or by law (e.g.
safety glasses, ear protectors, safety boots, suitable safety clothing). Observe the regulations for the
prevention of accidents! Observe all safety precautions and warnings attached to the product and
always keep them in good and perfectly legible condition.
The personal protection equipment should consist of the following parts:
1
Helmet with protection of the ears
2/3
Visor or safety glasses / Dust mask
4
Protective gloves
5
Safety clothes
6
Safety boots
