GÖLZ Bridge Saw, Original Operating Manual, Page: 35 / 86

8 Operating
35 / 86
8.5.2 45°- bevel cuts
The machine offers the possibility to perform 45° bevel cuts.
For 45° bevel cuts we proceed as follows:
1. switch off the machine -> the cutting disc must not turn!
2. loosen the star knob screws on the bridge on both sides of the machine
3. swivel the complete cutting head with bridge into the desired position. Use the scale on the
side for orientation.
4. retighten the star knob screws.
5. next, loosen the adjusting screw.
6. adjust the depth stop and fix this setting
7. place the material to be machined on the table Check the position of the material using the
angle stop.
8. start the engine and the water pump and open the water tap
9. grasp the chain-guided crank handle on the cutting head with your right hand and the
transport handle on the machine frame with your left hand
10. Then crank the cutting head slowly and without pressure over the loaded material. The
cutting disc will then cut through the loaded material.
To return the guide bridge with cutting head to the 90° position after this cutting operation, proceed
as follows:
1. switch off the machine -> the blade must not turn!
2. loosen the star knob screws on the bridge on both sides of the machine
3. swivel the complete cutting head with guide bridge into the desired position
4. tighten the star knob screws again.
NOTE!
Hold the cutting head in the 90° position with one hand. Tightening the nut could reverse the
angle so that the cutting head is not exactly at 90°.
NOTE!
The cutting wheel must not touch the material to be cut, regardless of its position or the position
of the cutting head!
NOTE!
The cutting disc must not touch the material to be cut or the fence angle, regardless of its
position or the position of the cutting head!
NOTE!
In an emergency, use your left hand to operate the emergency stop button on the switch.