GOLDENSEA UV UVL220, Quick Start Manual

Page: 15 / 20

www.goldenseauv.com
10
10. Replacing The UV Tube
To maintain the sterilizing efficacy, the UV tube needs to be replaced after 9,000 hours of
use.
Steps:
1. Wait for UV tube to cool down (to avoid scalding) after switching off the device.
2. Pull up the locking tabs
①
on both sides of the device, and open the protective grid as
shown.
3. Remove the safety catch
②
of the UV tube, move the UV tube out of its holder from
left to right
③
as shown and take it out.
Note: please follow your local toxic and hazardous waste regulations for lamp
disposal.
4. Insert the new UV tube into the holder of the device and move the UV tube towards
the left until it fits into place correctly and tightly.
Note: direct contact with new UV tube should be avoided as grease from your skin
may reduce the efficiency of the UV tube. It is advised to wear protective gloves when
handling a new UV tube.
5. Fix the safety catch
②
back to the UV tube holder.
6. Install the protective grid back onto the device and push down the locking tabs
①
on
both sides of the device. The device is ready for use now.