18
ATTACH V-BUNK BRACKET**
Note: This step only applies to the 18K capacity Tornado Boat lift.
When assembling the 15K Capacity lift, please skip to the next
step.
1.
Align the
1/2” holes of the V
-Bunk Brackets so that they are
above and below the V-Bunk arm as shown in Figure 18.
2.
Attach one (1) 1/2" Flat Washer over two (2) 1/2" Hex Bolts
and insert them into the corresponding holes as shown in
Figure 18.
3.
Attach one (1) 1/2" Lock Washer and one (1) 1/2" Hex Nut over
the protruding ends of the Hex Bolts and hand tighten.
Note: It is important not to over tighten Hex Nuts to allow for
adjustability.
5.
Repeat these steps seven (7) more times, once for the other
side of the V-Bunk, and six more times for the other V-
Bunks.
Note: Please return to this step when instructed to fully tighten
hardware.
PARTS REQUIRED TO MOUNT V-BUNK
BRACKET
1/2
” Flat
Washer (32)
1/2
” x
4-
1/2” Hex Bolt
(16)
1/2
” Lock Washer (
16)
1/2
” Hex Nut (
16)
V-Bunk Brackets (16)
Figure 18
