7
ATTACH FOOT PADS
Note: The Foot Pad(s) referenced in this step is an optional part
purchased with the Tornado Boat Lift. If the Foot Pad part was not
ordered and included, you may skip to the next step.
1)
Attach one (1) Foot Pad to the end of one (1) Square Tube Leg
from previous step and align as shown in Figure 3.
2)
Attach one (1) 3/8” Flat Washer to one (1) 3/8” Hex Bolt and
insert through hole(s) in the Foot Pad and Square Tube Leg
as shown in Figure 3.
3)
Attach one (1) 3/8” Lock Washer and one (1) 3/8” Hex Nut to
the protruding end of the Hex Bolt and securely fasten with
appropriate wrench until secure.
4)
Repeat these steps for the remaining three (3) Foot Pads.
PARTS REQUIRED TO ATTATCH FOOT PAD
Foot Pad (4)
3/8” Flat Washer (4)
3/8” x 4
-
1/2” Hex Bolt
(4)
Square Tube Leg (4)
3/8” Lock Washer (4)
3/8” Hex Nut (4)
Figure 3
Figure 4
Summary of Contents for Tornado 4-CYLINDER
Page 4: ...4 ...
