6
Figure 2
MOUNT CROSSBEAMS
Note: Cross Beams will ship with leg pockets pre-assembled.
Note: Ensure Crossbeam and Leg Pocket is oriented in the
upward position as shown in Figure 1.
Note: The Square Tube Leg(s) referenced in this step is an
optional part purchased with the Tornado Boat Lift. If the Square
Tube Leg part was not ordered and included, you may skip to the
next step.
1.
Slide Crossbeam Leg Pocket over Square Tube Leg as
shown in Figure 1 and adjust to desired height.
2.
Attach one (1) 3/8” Flat Washer onto two (2) 3/8” x 4
-1/2
” Hex
Bolts and insert them into Leg Pocket, securing the
Crossbeam to the Square Tube Leg shown in Figure 2.
3.
Attach one (1) 3/8” Flat Washer, one (1) 3/8” Lock Washer,
and one (1) 3/8” Hex Nut over the two (2) protruding ends of
the Hex Bolts and securely fasten with appropriate wrench
until secure as shown in Figure 2.
4.
Repeat these steps three (3) more times, once for the
opposite side of the Cross Beam, and twice for the second
Cross Beam.
PARTS REQUIRED TO MOUNT CROSSBEAM
Leg Pocket
3/8” Flat
Washer (16)
3/8” x 4
-
1/2” Hex Bolt
(8)
Crossbeam (2)
3/8” Lock Washer (8)
3/8” Hex Nut (8)
Square Tube Leg (4)
Figure 1
Summary of Contents for Tornado 4-CYLINDER
Page 4: ...4 ...
