16
ATTACH GUIDE POLE(S)
Note: The Guide Poles referenced in this step are optional parts
purchased with the Tornado Boat Lift. If the Guide Pole part was
not ordered and included, you are finished with the Tornado Boat
Lift installation.
1.
Insert the Guide Pole into the Guide pole Mounting Bracket
so that the Guide Pole arm is facing outward and upward as
shown in Figure 18.
2.
Adjust the Guide Pole to the desired outer dimensions and
align the mounting holes accordingly.
3.
Attach one (1) Flat Washer to one (1) Hex Bolt and insert into
the mounting hole.
4.
Attach one (1) Flat Washer, one (1) Lock Washer, and one (1)
Hex Nut to the protruding end of the Hex Bolt and fasten
with appropriate wrench until secure.
5.
Repeat this step three (3) more times, once for the opposite
end of the Bunk, and twice for the second Bunk.
Note: It is important to review all the steps in this manual before
operating the Tornado Boat Lift to ensure all parts and hardware
have been installed correctly. Failure to do this may result in
damage to the Tornado Boat lift and/or serious injury/death.
PARTS REQUIRED TO INSTALL GUIDE POLE
Guide Pole (4)
3/8” Hex Nut (4)
3/8” Lock Washer (4)
3/8” x 4
-
1/2” Hex Bolt (4)
Figure 18
3/8" Flat Washer (8)
Summary of Contents for Tornado 4-CYLINDER
Page 4: ...4 ...
