background image

 

 

For Customer Service, contact the place of purchase to arrange for replacement parts.

 

CSA055304DALG1 

 

INSTALLATION INSTRUCTIONS 

 

 

Fixture Name: AUTUMN TWILIGHT 9903-M1L MG 
For Pendant Light Fixture 

 

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER

 

 

Fig.1  

 

HANGING THE FIXTURE

Fig.1

 

1. Carefully remove the new fixture from the carton and the 

yellow bag that holds all parts. Check that all parts are 

included as shown in the illustration and parts list. 

2. Shut off the power at the circuit breaker and remove old 

fixture from ceiling, including the old mounting strap. 

3. Thread Nipple(C) into Canopy Loop (F) until snug. 

4. Thread other end of the Nipple (C) with Canopy Loop 

attached into Mounting Strap (D). 

5. Place Lock Washer (B) over end of Nipple (C) protruding 

through Mounting Strap (D) and thread Hex Nuts (A) onto 

Nipple until tight. 

6. Take this mounting strap assembly and mount to ceiling 

junction box with junction box Screws (E). Tighten screw 

securely with screw driver. 

7. Unscrew the Canopy loop collar (H) from the Canopy 

loop. Take the canopy and pass over the Canopy loop. 

Approximately one half of the canopy loop exterior 

threads should be exposed. Adjust until desired height is 

reached. You may need to cut short the wire and 

reconnect with transformer refer original mode. *the 

Canopy loop collar should fit snugly on the Canopy loop 

after the canopy is installed. Remove Canopy and 

Canopy loop collar. 

8. Assemble the fixture and have an assistant or secure 

support hold the weight of the fixture while you complete 

the wiring connections.

   

9. Thread the fixture wires and ground wire of the 

assembled fixture through the canopy loop (F) and 

nipple(C) and chain (every three links) into the outlet box. 

CONNECTING THE WIRES (Fig.2) 

10. Attach the power supply wires to the fixture lead wires 

by connecting BLACK to BLACK (or SMOOTH) and WHITE 

to WHITE (or RIBBED). 

11. Attach the GROUND wire (GREEN or COPPER) from the 

Junction Box and the fixture Ground wire to the green 

Ground Screw on the Mounting Bracket (B) or connect 

both wires together using the correct size of wire 

connectors. 

NOTE: Twist the wires together in the same direction you 

twist the wire connector onto the wires. 

12. Tuck these wire connections neatly into the Junction 

Box. 

FINISHING THE INSTALLATION (Fig.3) 

13. Raise Canopy (G) to the ceiling and secure in place by 

tightening the Canopy loop collar (H) into the Canopy 

Loop (F). 

14. Install the light bulbs and crystals as per the fixture 

assembly sheet. 

YOUR INSTALLATION IS NOW COMPLETE. TURN POWER ON AT 

TO THE JUNCTION BOX & TEST THE FIXTURE. 

 

Fig.2 

FIXTURE WIRES 

 

SMOOTH 

(or Black) 

 

RIBBED 

(or White) 

 

BARE COPPER 

(or Green)   

HOUSE WIRES 

 

BLACK 

(Hot) 

 

WHITE 

(Neutral) 

 

GREEN 

(Ground) 

JUNCTION BOX

(CEILING)

A

B

D

C

E

F

I

I

G

H

CHAIN

J

Reviews: