INSTALLATION AND OPERATING
INSTRUCTIONS
FOR VENT-FREE
OR VENTED INSTALLATIONS
GOLDEN BLOUNT “TEXAS FLAME II” GAS LOGS
NATURAL GAS OR L.P.
18“ - 24“ & 30“ SIZE SETS
The Golden Blount vent-free gas
log sets comply with the National
Safety Standards and are tested
and design certified by CSA to
ANSI Z21.11.2-2000, unvented
heaters Z21.60a-2000 decorative
gas appliances for installation only
in a woodburning, masonry or UL
listed manufactured fireplace or in a
Golden Blount or any other CSA
approved vent-free fireplace. This
product may be burned with the
fireplace damper in either a closed
or open position.
Warning:
If the information in this manual is
not followed exactly, a fire or explosion may
result causing property damage, personal
injury or loss of life
• Do not store or use gasoline or other
flammable vapors or liquids in the
vicinity of this or any other appliance.
• What to do if you smell gas:
- Do not try to light any appliance.
- Do not touch any electrical switch;
do not use any phone in your
building.
- Immediately call your gas supplier
from a neighbor’s phone.
- If you cannot reach your gas
supplier, call a fire department.
- Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
Warning:
Logs must be arranged so that the
flames only touch bottom back log or front
ember log. Flames must not touch any other
log in set or any part of firebox.
This is an unvented gas-fired heater. It
uses air (oxygen) from the room in which
it is installed. Provisions for adequate
combustion and ventilation air must be
provided.
MANUFACTURED BY:
4301 WESTGROVE DRIVE
ADDISON, TX. 75001
INC.
D
E S I G N
C
E
R T I F I E
D ®
