737 MAX Flight Crew Operations Manual
Supplementary Procedures -
Flight Management, Navigation
SP.11.8
MN-FLT-OH-201
Note:
If ETA and DTG are not displayed, the fix radial and/or
distance do not intersect the route.
Changing Destination
RTE page ........................................................................................ Select
Enter the new destination over the original DEST. Enter desired
routing to the new destination using the RTE, RTE LEGS, and
ARRIVALS pages, as appropriate. Correct any ROUTE
DISCONTINUITY.
EXEC key ........................................................................................ Push
Observe the MOD RTE or MOD RTE LEGS page changes to ACT.
Note:
If destination is changed during climb, performance predictions
may be blanked if the new flight plan is incompatible with the
entered cruise altitude. Correct by entering a lower CRZ ALT
on the CLB page.
Entering Holding Fix Into Route
HOLD key ........................................................................................ Push
(If RTE HOLD page is displayed, observe NEXT HOLD prompt.
Line select 6L until (RTE LEGS) HOLD AT page is displayed.)
Observe HOLD AT box prompts and PPOS prompt (if in flight) are
displayed. Enter the holding fix in line 6L, or line select PPOS.
If the holding fix is a waypoint in the active route, or PPOS was
selected, observe MOD RTE HOLD page displayed. If the holding fix
is a waypoint not in the active route, observe message HOLD AT
XXXXX displayed in the scratch pad. Enter the holding fix into the
route by line selecting in the desired waypoint sequence. Observe the
MOD RTE HOLD page displayed. If displayed holding details are
incorrect or inadequate, enter correct information on appropriate
line(s).
EXEC key ........................................................................................ Push
Observe MOD RTE HOLD page changes to RTE HOLD (ACT RTE
HOLD if holding at PPOS).
Exiting Holding Pattern
HOLD key ........................................................................................ Push
Observe EXIT HOLD prompt displayed.
March 1, 2021
