7
Hardware Installation
1.
Power off all devices including your HDMI source
and HDMI display(s).
2.
Install the included antennas to the TX and RX.
3.
Connect your HDMI source device to the
Transmitter's HDMI In port with an HDMI cable
(HDMI cable not included).
4.
Optional: Connect an HDMI display to the
Transmitter's HDMI Loopout port with an HDMI
cable (HDMI cable not included). This connection
is needed only if you require monitoring of the
remote HDMI display.
5.
Optional: Connect the included IR Emitter cable to
the Transmitter's IR Out port. Face the eye towards
your HDMI source device's IR window. This
connection is needed only if you need to control
your HDMI source from the remote location.
6.
Connect your HDMI display to the Receiver's HDMI
Out with an HDMI cable (HDMI cable not included).
7.
Optional: Connect the includeded IR Receiver cable
to the Receiver's IR In port. This connection is
needed only if you need to control your HDMI
source from the remote location.
8.
Plug the included power adapters into the
Transmitter's and Receiver's Power Jacks, then plug
both power adapters into reliable power outlets.
9.
Power on your HDMI source device and HDMI
display.The wireless extender is ready for use.
Note
: For optimal signal range, install in a clear
environment with few obstacles. Wireless signals
from other devices, such as microwaves, smart
phones,wireless mice and keyboard, etc. may
interfere with transmission.