1 Introduction
2
1.3 EMC Protection Measures
The
Easy CON
complies with the Electromagnetic Compatibility Directive (2014/30/EU).
In order to comply with the electromagnetic compatibility, the system may only be operated in the delivered
condition. Mechanical and electrical changes of any kind are not allowed. Use only suitable shielded signal and
control cables.
If the product is installed and operated in a system with other equipment, accessories and compo-
nents, the system as a whole and all its equipment, accessories and components must conform to the
EMC directives and standards. The system integrator is responsible for compliance with the EMC Direc-
tive 2014/30/EU and national EMC laws for installed systems, system accessories and system compo-
nents that have not been supplied or tested and approved by
GOEPEL electronics
as manufacturer of
the equipment.
1.4 EU Declaration of Conformity
The EU Declaration of Conformity can be found in the appendix to this documentation.
1.5 General Safety Regulations
To avoid personal injury and / or property damage, follow these general safety instructions.
Risk of accident due to electric shock or fire
•
In addition to the operating instructions, observe the legal requirements and regulations for accident
prevention and environmental protection of the countries in which you operate the system.
•
Do not make any changes to the system without the written consent of the manufacturer.
•
Never operate damaged devices or components.
•
Keep liquids away from the unit and do not place any containers with liquid on the unit.
Danger of tripping or falling due to improperly laid cables
•
Lay cables so that nobody can step on them or trip over them.
•
Never try to stretch cables to enable a connection. The cables must always have enough clearance.
Damage caused by improper use or failure to observe the safety instructions and warnings is not covered by the
warranty. For consequential damages no liability is assumed by
GOEPEL electronics
!
1.6 Liability and Warranty Exclusion
The
Easy CON
has not been developed, tested or intended for use in safety-related applications. Do not use the
device for safety-related systems or vehicle subsystems. The use of such a device within motor vehicles to con-
trol the main vehicle functions can be dangerous and lead to malfunction of motor vehicles.
In no event shall
GOEPEL electronics
be responsible for any direct, indirect, incidental, special, exemplary, or
consequential damages (including but not limited to the purchase of replacement goods or services, loss of use,
loss of data or profit, breakdowns, injury, or potential death) in any way in the case of improper use of the
Easy
CON
Media Converter.